Model 675b – Troy-Bilt REAR-TINE TILLER 675B User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MODEL 675B
REF
NO.
PART NO.
DESCRIPTION
REF
NO.
PART NO.
DESCRIPTION
1
GW-1714
Bearing, Tapered Roller with Race
GW-1325C
Shim Set (Inch two GW-1224-1; two 1224-
1a
GW-9400
Drive Shaft Bearing Cup
2 and one GW-1224-3 (A/R)
1b
GW-9401
Drive Shaft Bearing Cone
6
GW-9572
Hex Hd. Screw, 5d6-24x1-1/8*1
2
GW-20718
Spur Gear
7
GW-9944
Washer, Disc Spring (concave surface faces
3
GW-9301
Key, S16sq.x1
pulley)
4
1916597
Rolled Drive Shaft (Drive shaft is one-piece
8
1108841
Key, 316 sq. x 1-1/2
with integral, single-lead, work-hardened
9
1916522
Transmission Drive Pulley
front worm, and integral, six-lead work-
10
GW-1440
Support Washer
hardened rear worm. Also includes
11
721-04044
Oil Seal, Input Pinion Shaft
pressed-on GW-1714 and GW-9301)
12
1113527
Retaining Ring (external)
5
GW-1224-1
Shim, Rear Bearing Cap,.010" thick, see
Note below (A/R)
13
14
GW-9953
GW-9428
Thrust Washer
Bushing
5
GW-1224-2
Shim, same as above, but.030" thick, see
Note (A/R)
Shim, same as above, but.005" thick, see
15
GW-9677
Set Screw, 506-18x38*
5
GW-1224-3
16
GW-20791
Input Pinion (steel shaft)
Note (A/R)
17
GW-20792
Input Pinion Gear
5
GW-1224-4
Shim, same as above, but.062” thick, see
18
GW-9093
Retaining Ring (external)
Note (A/R)
19
GW-20799
Pinion Assy. (Incl. Refs. 16,17 & 18)
20
GW-9517
Retaining Ring
NOTE: Shim between drive shaft rear bearing and rear bearing cap to achieve 5-to-15 thousandths of an inch (.005-.015) end piay on drive shaft.
A/R - As Required
* Specify GRADE 5 if ordering part locally.
29