Cisco Cisco Unified Communications Server 2000.4.3a - Manual (Page 31)

31
Installing the Operating System on the Cisco Unified Communications Server, Versions 2000.4.3 and 2000.4.3a
OL-10221-02
Error Messages
The current version of the RAID Firmware is
<number>
The RAID Firmware version tested on this system
is <number>
Please note this system has not been tested with
the detected RAID Firmware version of
<number>
Press 'OK' to continue or 'Cancel' to abort the
installation
RAID Firmware Version Warning
This message displays when the RAID firmware
on the server represents a later release than the
version that was tested. To continue the
installation, click OK. The installation does not
downgrade RAID firmware.
The current version of the RAID Firmware is
<number>
The RAID Firmware version tested on this system
is <number>
The RAID Firmware will be automatically
adjusted as part of this installation.
Press 'OK' to continue or 'Cancel' to abort the
installation.
RAID Firmware Version Warning
This message displays when the RAID firmware
on the server represents a different release than
the version that was tested. To continue the
installation, click OK. The installation upgrades
or downgrades the RAID firmware to the tested
version.
The current version of the RAID BIOS is
<number>
The RAID BIOS version tested on this system is
<number>
The RAID BIOS will be automatically adjusted as
part of this installation.
Press 'OK' to continue or 'Cancel' to abort the
installation.
RAID BIOS Version Warning
This message displays when the RAID BIOS on
the server represents a different release than the
version that was tested. To continue the
installation, click OK. The installation upgrades
or downgrades the RAID BIOS to the tested
version.
The transfer of the OS image to the hard drive
failed!
This can be caused by scratched or smudged
DVD-ROM media or a hardware failure within the
system.
Fatal Error
This message displays when the installation
cannot properly transfer the operating system to
the hard drive. Verify the condition of the DVD
media and attempt the installation again.
A failure to program the BIOS was encountered.
Error Code: <number>
Fatal Error
This message displays when the installation
cannot configure the system BIOS. Verify the
health of server, and attempt the installation again.
Table 6 Error Messages (continued)
Error Message Corrective Action