MTD 24677L - Manual (Page 8)

FLANGE \ r; - ^
tiVIPELl
GUARD (S)
IS- ....-- ’ " ‘ . ■ ' s . i ■ i"«
i " ; - ^ r / '.i,-- VY I
■ •'■'■-• WASHE j
HAND KNOB81
i-
FLA
/ ■ •
FIGURE 13
5. Lift up and out on the housing and rotate it 105°
clockwise. Chute opening should be to the right,
hand side when viewed from the front of uni*
See figure 13.
6. Place the impeller guard (S) into flanges on front
of housing. Line up hole in screen with hole on
housing. Secure with one hand knob, belleville
washer and heavy flat washer (H). See figure 13.
N
Dl RECTI PNAL
DISCHAI GE
ASSEMB .Y (R)
7. Place the directional dishcarge assembly (R) over
chute opening. Secure with two hand knobs ans
belleville washers. See figure 14.
FIGURE 14
ASSEMBLY INSTRUCTIONS
for Tow Bar Kit
1 .
2
.
Remove the self-tapping screws on each side of
frame. Refer to drawing on page 12, reference
number 42.
Place tow bar half in position on frame. Place
one shoulder spacer (V) between frame and
tow bar. Next, place shoulder spacer (V) and hex
bolt (U) through tow bar and frame. Secure with
hex nut (W). See figure 15. Repeat for other side.
3. Secure the two tow bar ends together with truss
machine screws (X), lock washers (Y) and hex
nuts (Z). See figure 15.
To attach the tow bar to a hitch, place the shoulder-
bolt (AA) up through the tow bar. Place one bellevil*
washer (AB) on the shoulder bolt, then the hitc
place and the other belleville washer. Cupped side of
the washers must be against the hitch plate. Secure
with hex jam lock nut (AC). See figure 15.