MTD 249-689-000 - Manual (Page 5)

1. Place nozzle (N) in position on front of housing
so that it rests in flanges. Secure with one hand
knob (F) and belleville washer (G). See figure 4.
NOZZLE (N)
FIGURE 4
UPPER
HANDLE (O)
2. Place the upper handle (0) in position over lower
handle. Fasten with four hex bolts (I) and lock
nuts (J) provided. See figure 5. Two 7/16"
wrenches are required.
FIGURE 5
3. Place the stud pins (K) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins with push-on speed nuts (L) by holding
speed nut with box wrench and tapping pin with
hammer. See figure 6.