Maintenance, Spark plug, Air filter – MTD 110-127R000 User Manual

Page 10: Service and adjustments, To adjust cutting height, Carburetor, Engine speed, Rear trail shield, Maintenance service and adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

NOTE: We do not recommend sharpening the blad

5

- but

if you do, be sure blade is balanced.

TO SHARPEN BLADE:

The blade can be sharpened with a file or on a

grinding wheel. Do not attempt to sharpen while on

the mower.

Careshouldbetakentokeepthebladebalanced.

An

unbalanced blade will cause excessive vib-ation

when running and eventual damage to mower and

engine.

To check blade balance, drive a nail into a be im or

wall. Leave about one inch of the straight nail

exposed. Place center hole of blade over the head
of the nail. If blade is balanced, it should rema n in a
horizontal position. If either end of the blade rx)ves

downward, blade is not balanced. Sharpen the

heavy end until the blade is balanced.

ENGINE

SPARK PLUG
Change your spark plug each year to make your engine

start easier and run better. Set spark plug gap at .025
inch.

AIR FILTER
Your engine will not run properly and may be dama< |ed by

using a dirty air filter.

Replace the air filter every year, more often if you r low in

very dusty, dirty conditions. Do not wash air filter. Filters

are available at your nearest Tecumseh Dealer.

CLEANING

A

CAUTION: DISCONNECT SPARK PLUG WIRE
FROMSPARK PLUG AND PLACE WIRE WHERE IT
CANNOT COME IN CONTACT WITH THE SPARK
PLUG.

Turn mower on its side with carburetor up.

Clean the underside of your mower by scraping to

remove build-up of grass and trash.

NOTE: We recommend that you clean the underside of

your mower after each use.

Clean your mower and engine often to keep build-up

of trash from accumulating around engine. A
clogged engine runs hotter and shortens engine life.

NOTE: We DO NOT recommend using a garden hose to
clean mower unless the electrical system, muffler, air

filterandcarburetorarecoveredtokeepwaterout.

Water

in engine can result in shortening engine life.

SERVICE AND ADJUSTMENTS

TO ADJUST CUTTING HEIGHT

See "ADJUST CUTTING HEIGHT" in operation section

of manual.

CARBURETOR

Your carburetor has a non-adjustable fixed main jet for

mixture control. If your engine does not operate pi operly
due to suspected carburetor problems, take your nower

to a authorized Service Center for repair and adjus tment.

ENGINE SPEED

Your engine speed has been factory set. Do not attempt
to increase engine speed or it may result in personal

injury. If you believe that the engine is running too fast or

too slow, take your mower to an authorized Service
Center for repair and adjustment.

REAR TRAIL SHIELD

The rear trail shield, attached between the rear wheels of

your mower, is provided to minimize the possibility that
objects will be thrown out the rear of the mower into the
operator mowing position.

If the shield becomes damaged, it should be replaced.

10

Advertising