Assembly, Attach upper handle (see fig. 1), Assemble grass catcher (see fig. 3) – MTD 110-127R000 User Manual
Page 6: Ahach trimplate (see fig. 2), To attach grass catcher (see fig. 4)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your lawn mower has been completely assembled«¡t the
factory except for the upper handle, trimplate and {rass
Cgtchor
TO REMOVE MOWER FROM CARTON
•
Remove loose parts if included with mower, (i.e.
trimplate and hardware pack, etc.)-
•
Cut down corners on one end of carton and lay end
down flat.
•
Remove packing material.
•
Roll mower out of carton and check carton :hor-
oughly for loose parts.
HOW TO SET-UP YOUR LAWN MOWER
ATTACH UPPER HANDLE (See Fig. 1)
•
Unfold lower handle rearward into operating posi
tion. BE CAREFUL NOT TO PINCH OR KINK THE
ENGINE CONTROL CABLE. Tighten knob seci irely
on right side of lower handle.
•
Position upper handle so operator presence co ntrol
bar is on top and assemble to lower handle with
saddle bolts, curved washers and knobs as shown.
•
Tighten knobs securely.
•
Secure engine cable to lower handle with plast c tie
(See Fig. 5).
ASSEMBLE GRASS CATCHER (See Fig. 3)
AHACH TRiMPLATE (See Fig. 2)
• Attach trimplate to lower handle with two (2) #10
sheet metal screws and tighten securely.
A
CAUTION: DO NOT RUN YOUR UWN MOWER
WITHOUT THE CHUTE DOOR OR APPROVED
GRASS CATCHER IN PLACE.
•
With frame handle upwards, slip frame inside of bag
so plastic bag panel is at bottom.
•
Snap sleeves around bag opening onto catcher
frame as shown.
TO ATTACH GRASS CATCHER (See Fig. 4)
•
Place grass catcher on the ground behind the lawn
mower.
•
Stand on the left side of the mower and open chute
door with your left hand.
•
With your right hand, reach through lower handle to
lift grass catcher and push forward to hook frame
onto deck mounting ears.
•
After catcher is positioned snugly on mower, release
chute door and allow it to rest on catcher handle.
TO REMOVE GRASS CATCHER
•
Simply lift up chute door and pull catcher up and
away from mower.
A
CAUTION: UNDER NORMAL USAGE, TH E CATCHER
MATERIAL IS SUBJECT TO DETERIORATION AND
WEAR AND SHOULD, THEREFORE, BE CHECKED
FREQUENTLY FOR REPLACEMENT. ANY RE
PLACEMENT CATCHER SHOULD BE CHECKED TO
ENSURE COMPLIANCE WITH ORIGINAL MANUFAC
TURER SPECIFICATIONS.