MTD 465 - Manual (Page 5)

A
WARNING: - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your chipper shredder.
WARNING: DO NOT OPERATE
THIS MACHINE UNLESS THE
CHUTE DEFLECTOR HAS BEEN
PROPERLY INSTALLED AND IS
SECURED
WITH THE HAND
KNOBS.
A DANGIII
ROTATING CUTTING BLADES.
KEEP HANDS AND FEET OUT
OF OPENING WHILE MACHINE
IS RUNNING.
■8k . ■PjllMk^N1 %ll mm
ROTATING CUTTING BLADES.
KEEP HANDS AND FEET OUT
OF
OPENINGS WHILE MACHINE
IS RUNNING.
S A F E T Y
GLASSES
S H O U L D
BE WORN
DON'T DEPOSIT MATERIAL
LARGER THAN 1/2 INCH „
DIAMETER IN THE HOPPER S
THIS MAY CAUSE DAMAGE ^
TO SHREDDING MACHINE.
▲ DANGER
ASSEMBLE CHUTE DEFLECTOR
TO THIS UNIT
BEFORE OPERATING MACHINE.
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder vacuum is observed from the
operating position.
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e.,
operator’s manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material.
• Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton (see Figure d
• Hopper Assembly
• Discharge Chute
• Chipper Chute (463 thru 465)
• Bag (Not Shown)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder, disconnect the
spark plug wire from the spark plug and ground against
the engine.