Section 3; know your chipper shredder, Stopping engine, Section 4: operating your chipper shredder – MTD 465 User Manual
Page 7: Know your chipper shredder, Operating your chipper shredder
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3; KNOW YOUR CHIPPER SHREDDER
Read this operator’s manual and safety rules before
operating your chipper shredder vacuum. Compare the
illustrations in Figure 5 with your unit to familiarize
yourself with the location of various controls and
adjustments. Save this manual for future reference.
Starter Handle
The starter handle is located on the engine. Pull the
starter handle to start engine. See Figure 5.
Release Rod
The release rod is located on the impeller bracket
assembly and it is used to release or lock the hopper
when raising or lowering. See Figure 5.
Chipper Chute
Allow twigs and small branches up to 3” in diameter on
models 463 thru 465 and 2” in diameter on models 462
to be fed into the impeller for chipping. See Figure 5.
Hopper Assembly
Allow leaves and small branches up to 1/2 diameter to
be fed into the impeller for chipping and shredding.
Material can be raked into hopper assembly by
lowering the hopper assembly. See Figure 5.
Bag (Not Shown)
Collects shredded or chipped material fed through the
chipper chute or hopper assembly.
Throttle Control Lever (Not Shown)
The throttle control lever is located on the engine. It
controls the engine’s speed and stops the engine. See
separate engine manual packed with unit for details.
Engine Controls
See the separate engine manual for the location and
function of the controls on the engine.
Stopping Engine
•
Move throttle control lever to STOP or OFF
position.
•
Disconnect spark plug wire from spark plug and
ground against the engine.
SECTION 4: OPERATING YOUR CHIPPER SHREDDER
▲
WARNING: The operation of any chipper
shredder can resuit in foreign objects
being thrown into the eyes, which can
damage your eyes severeiy. Aiways wear
the safety giasses provided with this unit
or eye shieids before chipping or shred
ding
and
while
performing
any
adjustments or repairs.
Gas And Oil Fill-Up
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your chipper
shredder vacuum. Read instructions carefully.
WARNING: Never fill fuel tank indoors with
engine running or until the engine has
been allowed to cool for at least two
minutes after running.
A.