Sekonic L-358 - Manual (Page 33)

-29-
6. Advanced Functions
CAUTION
• When using quad channels 17-32, it is not possible to terminate this mode unless a sub-
channel has been set (a, b, c or d is displayed).
4. In the Setting mode, "ch" appears on the ISO display area. At the same time, channel numbers
(1 to 16 and 17 to 32) appear on the F stop area. When the channel number is 17 to 32, sub-
channel (A, b, c and d) settings are displayed on the T indicator. In the absence of settings, "-
" appears in the figures.
5. In sub-channel settings, after the channel is set to 17 to 32, the mode button is pressed. Following
this, the 4th figure on the T (shutter speed) area blinks to indicate that settings may be made.
Every time the mode button is pressed, the blink shifts from sub-channel No. : 4th figure → 3rd
figure → 2nd figure → 1st figure → channel No., while permitting settings for each sub-channel.
As the Jog wheel is rotated in this state, setting ("A, b, c and d" displayed) and resetting ("-"
displayed) alternate. During this process, the indicator continues to blink to indicate the channel
being set.
→ Set by manipulating the mode set button.
↔ Set by manipulating the Jog wheel.
6. Upon setting completion, the Wireless flash radio triggering mode or Wireless multiple flash
radio triggering mode is selected using the Jog wheel while the mode set button is depressed.
For othe setting of measuremends see page 16 of “Cord flash”.
7. Confirm that the meter and the radio receiver are set to the same channel number. The flash
unit will fire when the measurement button of the meter is pressed and measurements can be
made at the same time.