Champion juicer G5-NG-853-S - Manual (Page 7)

6
Disassembly
After shutting off the juicer, disconnect the power cord. Rotate the body clockwise
until the body notches and the hub prongs are aligned. Jiggle the body slightly and
remove. The screen (or blank), screen holder and cutter should slide off easily.
However, if the cutter becomes vacuum locked, use a small screwdriver to pry forward.
A build-up of pulp behind the cutter and against the motor hub is normal.
STEP 4
Pull the body forward slightly, so it is completely clear of the prongs on the motor hub.
Rotate the body one notch to the left, (counter clock-wise), and match the openings
in the back of the body with the prongs on the motor hub. Slide the body all the way
back and turn it to the left until it stops. It is now properly assembled for juicing.
STEP 5
Plug into power outlet.
STEP 6
To homogenize, unplug the juicer and replace the screen with the blank.
STEP 7
Add the funnel when using small feeding materials such as berries and nuts. Do not
use the funnel when juicing large foods.
If the Champion 2000+ Juicer doesn’t operate at this point, all parts may
not have been assembled properly. The screen (or blank) holder must be
assembled correctly for the motor to operate. Unplug and reassemble
carefully, following the complete instructions.
Assembly Instructions