NETGEAR N600 Wireless Dual Band Gigabit Router WNDR3700v3 - Manual (Page 16)

Installing Your Wireless Router Manually (Advanced and Linux Users) 12
Control Panel of your computer. If you are unsure about this, refer to the documentation for your
computer or see the link to TCP/IP Addressing in
“Related Documents” on page 39 .
There are two steps to setting up your N600 wireless gigabit router:
1. Connect the router to the ADSL or cable modem, and connect a computer to the router.
2. Configure the router to use your Internet service.
To connect your N600 wireless gigabit router:
1. Connect the N600 wireless gigabit router, the computer, and the modem.
a. Turn off your computer.
b. Turn off and unplug the cable or ADSL broadband modem. If your modem has a backup
battery, remove it as well.
c. Locate the Ethernet cable (1) that connects your computer to the modem.
2. Disconnect the cable from the modem (2). You will connect it to the router later.
3. Locate the Ethernet cable that came with the NETGEAR product. Securely insert that Ethernet
cable into your modem and into the Internet port of the N600 wireless gigabit router (3).
If you are replacing an existing router, disconnect it completely from your network
and set it aside before starting to install your new router.
Figure 5
1
2