Setting – Canon LV-S4 User Manual

Page 40

Advertising
background image

40

Setting

Capture

This function enables you to capture the image being projected
and use it for a starting-up display or interval of presentations.
After capturing the projected image, go to the Logo function and
set it to “User”. Then the captured image can be displayed when
turning on the projector next time or pressing the NO SHOW
button. (p22)
To capture the image, select [Yes]. To cancel the Capture
function, select [No].

Note:

• Before capturing an image, select Standard in the Image Select Menu to capture a

proper image. (See page 29, 34.)

• A signal from a computer can be captured up to XGA(1024 x 768). A signal from

video equipment can be captured except for 720p, 1035i, and 1080i.

• When capturing the image that has been adjusted by the Keystone function, the

adjusted data is automatically reset and the projector captures an image without
keystone adjustment.

• When the Logo PIN code lock function is On, the Logo and Capture menu cannot

be selected.

• When starting to capture the new image, the previously stored image is cleared

even if you cancel capturing.

Select [Yes] to capture
the projected image.

Select [Yes] to
stop capturing.

Capture

Logo

This function decides what to be displayed on the starting-up
display as follows:

User . . . . . .the image you captured
Default . . . .the factory-set logo
Off . . . . . . .count-down only

Ceiling

When this function is “On”, the picture is top/bottom and left/right
reversed. This function is used to project the image from a ceiling
mounting the projector.

Rear

When this function is "On”, the picture is left/right reversed. This
function is used to project the image to a rear projection screen.

Ceiling

Rear

Advertising