Charnwood SLX20 User Manual
Page 7
glass clean, therefore, when lighting the stove allow the
firebed to become well established before turning the
thermostat down. It may sometimes be beneficial to also
keep the doors slightly ajar whilst the fire becomes
established. This can also apply when re-fuelling.
b) When re-fuelling keep the fuel back a little from the front
firebars, do not try to fit too much fuel into the firebox.
c) Never completely clse the airwash control - as a guide it
should be at least a quarter open.
d) Wet wood or logs overhanging the front firebars will
cause the glass to blacken.
It is always more difficult to keep the glass clean when
running the stove very slowly for long periods.
If blackening of the glass still occurs check that all flue
connections are well sealed. It is also important that the
chimney draw is sufficient and that it is not affected by
down-draught.Whenthechimneyis warm a draught
reading of at least 2.5mm (0.10 inches) water gauge should
be obtained.
Page 7
SLX20 9.03