Chamberlain ATS 2113X - Manual (Page 16)

16
Inside
Garage
Wall
“C” Shaped
Wrap
Mounting Bracket
with Square Holes
1/4-20x1/2"
Carriage Bolts
1/4"-20 Lock Nuts
Drill 3/8"
Holes
Garage
Door Track
Figure 3 Garage DOOR Track Installation
Mounting Bracket
With Square Holes
#10-32x3/8"
Screws
“C” Wrap
#10-32
Lock Nuts
Figure 1 Garage WALL or DOOR Track Installation
Mounting Bracket
with Slot
1/4"-20
Lock Nuts
1/4x1-1/2"
Lag Screws 1/4-20x1/2" Carriage Bolts
(with square shoulder)
Inside
Garage
Wall
“C” Wrap
Mounting Bracket
with Square Holes
Figure 2 Garage WALL Installation
Lag Screw 1/4x1-1/2" Screw
#10-32x3/8" Lock Nut
1/4"-20 Lock Nut
#10x32
Staples
Carriage Bolts
1/4"-20x1/2"
HARDWARE SHOWN ACTUAL SIZE
Figure 4 Alternate Wall Mount
“C” Wrap
Inside
Garage
Wall
Mounting Bracket
with Square Holes
Mounting Bracket
with Slot
Sensor
with wire
Indicator Light
Garage
Floor
INSTALLING THE BRACKETS
Figure 1, 2 and 3 show recommended assembly of bracket(s) and
“C” wrap based on the wall installation of the sensors on each side
of the garage door as shown on page 15, or on the garage door
tracks themselves.
Figure 4 and 5 are variations which may fit your installation
requirements better. Make sure the wraps and brackets are
aligned so the sensors will face each other across the garage
door.
Garage Wall or Door Track Installation
Fasten the “C” wraps to the mounting brackets having square 1.
holes, using th hardware shown in Figure 1.
Garage Wall Installation
Connect each assembly to a slotted bracket, using the hardware 2.
shown on Figure 2. Note alignment of brackets for left and
right sides of door.
Finger tighten the lock nuts. 3.
Use bracket mounting holes as a template to locate and drill 4.
(2) 3/16" diameter pilot holes on both sides of the garage door,
4"-6" (10-15 cm) above the floor but not exceeding 6" (15 cm)
(see warning on page 15).
Attach bracket assembly with 1/4"x1-1/2" lag screws as shown 5.
in Figure 2.
Adjust right and left bracket assemblies to the same distance 6.
out from mounting surface. Make sure all door hardware
obstructions are cleared. Tighten the nuts securely.
Garage Door Track Installation
Discard slotted bracket. Drill 3/8" holes in each track and fasten
securely with hardware as shown in Figure 3.
Garage
Floor
Indicator Light
Inside
Garage
Wall
Mounting Bracket
with Slot
Attach with
concrete
anchors
(not provided)
Mounting Bracket
with Square Holes
“C” Wrap
Sensor with wire
Figure 5 Alternate Floor Mount
Figure 3
Figure 1
Figure 2
Figure 4 Figure 5