Chicago Electric 10" Industrial Tile/Brick Saw 69275 - Manual (Page 14)

Page 14 For technical questions, please call 1-800-444-3353. Item 69275
SAFETY
OPERA
TION
MAINTENANCE
SETUP
General Operating Instructions
1. Fill the Water Tray with clean water up to
the Fill Rim (see Figure H on page 11)
before every use.
CAUTION: Water level must be kept above lip
of pump basin at all times during operation.
2. Adjust the Miter, Bevel, and Depth
settings as needed, see previous page.
Lock all settings in place.
3. Place the workpiece on the Table and firmly
against the Miter Gauge and Fence.
4. Make sure the workpiece is clear of the Blade,
then dry your hands, plug in the Saw, insert the Key
and turn the Power Switch to the ON position.
5. Make sure the pump is supplying enough water
to the Blade. If needed, dry your hands, unplug
the Saw, adjust the Pump′s flow control, dry
your hands again, and plug the Saw back in.
6. Let the Blade build up to full speed before cutting.
7. Hold the material firmly against the rip guide
and feed the material into the Blade.
8. When the cut is made, turn the Saw OFF.
Wait for the Blade to come to a complete stop
before removing any part of the workpiece.
9. To prevent accidents, turn off the Saw, remove the
Key, and unplug the Tile Saw after use. Clean,
then store the Saw indoors out of children’s reach.
Figure N: Straight Cut
Figure O: Miter Cut
Figure P: Bevel Cut