Bolens 113-084A - Manual (Page 6)

8.
9.
Place the throttle control lever on the handle
In “Fast” position.
Push the throttle control lever on the engine
to the full open position (as far toward the out­
side of the unit as it will go) as shown in figure
6 .
10. Hook the “Z” end of the throttle control cable
into the hole in the control lever on the
engine.
Loosen (do not remove) the screw on the
cable clamp shown in figure 6 . Slip the control
casing under the clamp. With the throttle lever
on the engine still in the full open position,
tighten the screw to secure the throttle con­
trol cable.
11 .
12. Secure throttle control cable and blade
brake/clutch cable to upper and lower handles
------with cable ties (D) provided. See figure 7.
13. Check all nuts and bolts for correct tightness.
FIGURE 7.
A
CAUTION
Please note that the chute deflector
on your mower is in an upright posi­
tion. It is held in that position by a
shipping block. This block is used
for shipping purposes only. It must
be removed and discarded before
your mower is put into operation.
■See figure 8 .