Bolens 112-340A - Manual (Page 7)

The grass catcher frame will snap into place,
-------secured by the lock lever. See figure 10.
To remove the grass catcher, unhook the lock
lever and slip the grass catcher off the unit. See
figure 10.
FIGURE 10.
OPERATION
DO NOT OPERATE THIS
MOWER WITH THE CHUTE
DOOR OPEN. UNLESS THE
COMPLETE GRASSCATCHER
IS PROPERLY MOUNTED ON
THE MOWER.
NOTE
For shipping purposes your mower
is set with the wheels in a low cut­
ting height position. For best
results, raise the cutting position
until it is determined which height
is best for your lawn. See adjust­
ment section.
BEFORE STARTING
DANGER
KEEP HANDS and FEET AUUAY
FIGURE11.
Keep hands and feet away from the chute area on
cutting deck. See figure 11.
1. Check to see that the handle is in the
operating detent in the brackets on the deck,
and the upstop projections restrict the handle
from moving up and forward. If necessary,
remove the left side from the mounting pin on
the deck bracket. Push inward to decrease the
spacing between the two sides of the handle
until it is slightly less than the spacing of the
deck brackets. Reinstall over the mounting
pin and secure the hairpin cotter in the inner
holes.
2. Fill sump with oil, using a high quality
detergent oil classified “For Service SC, SD,
SE or MS.” Use SAE 30 or SAE 10W-30 viscosi­
ty grade oil. Nothing should be added to the
recommended oil.
Place engine level. Remove oil fill plug. See
figure 12. Fill to point of overflowing. Pour
slowly. Capacity 1V4 pints.