Beko D1 6633 TS - Manual (Page 10)

Operating the hot plates
Hotplate control position
Corresponding Cooking Values
1 2 1 3 4 1 5 1 6
Application Warming Simmer/ng Cooking-Frying-Boiling
A rapid heating hotplate is denoted by a red spot in
the centre of the hotplate:
H o t p l a t e o p e r a t i n g k n o b s
The knobs for the hob can be rotated in either
direction to provide fully variable heat control. When
any one of the hotplates is on, t h e r e d
i n d i c a t o r l i g h t o n t h e c o n t r o l p a n e l
w i l l b e o n .
In order to switch the hotplate OFF turn the
corresponding knob to the
0
( z e r o ) position.
C h e c k t h a t a l l t h e c o o k e r c o n t r o l s
h a v e b e e n s w i t c h e d o f f a f t e r u s e .
Adjust the hotplates to mid position (3) and leave on
for approximately 8 minutes in order to burn off the
protective coating on the hotplates. Do not place any
pans or other cooking utensil on the hotplates during
this process. Fumes will be emitted during the above
operation but this is quite normal.
You should adjust the electronic timer prior to
using the hob. Otherwise your hob will not operate.
Right Pan
^Corree/ size)
G o o d Q u a l i t y P a n s
* Use only good quality pans having a stable bottom as shown below.
This results in the maximum use of energy.
* Use pans for the correct diameter
only. If the pan is too small energy
is wasted.
* Do not place pans with wet bases
or pan lids particulary wet lids on
the hotplates damage could occur
and safety problem will be
experienced.
Hotplate diameter Suggested diameter
(mm) of the pan (mm)
Wrong Pan
(Too small)
0 220mm
0 180 mm
0 145 mm
220-240
180-200
150-170
* D r y i n g t h e h o t p l a t e s
( m a x 5 m i n )
* When cool;
* Clean off solid hotplates with a damp cloth and a little domestic
cleaning cream. After cleaning, dry solid hotplates by switching on for
a short time. Apply a thin coat of cooking oil from to time.
* When wiping the hotplates with a damp cloth follow the circular
grooved pattern on the hotplate.