Arcam 8SE - Manual (Page 3)

Using your CD player - getting started
t > o o.
Ö o Ö o Ц Ц Ц
POWER
Press this button to switch the CD player on and off.
When first powered up with no CD installed you will see...
...first this ...then this
11
DISC D
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
REPEAT CHECK
■OWER
-r'.
O CO O O
LOAD (called OPEN on remote control)
To install a CD, press 'LOAD'. The CD tray opens, it accepts both
8 cm and 12 cm discs. Place the CD in the tray with the label side
uppermost. Press ‘LOAD’ again [or press ‘PLAY’, or gently push the
tray in 5mm], the tray closes. You will see 'DISC, along with the
total number of tracks and total disc time, eg.
i n C D 7 0
DISC l U - I t - . I D
1 2 3 4 5 6 7 8 9 1 0
If the disc has more than 16 tracks then the word 'OVER' is also
shown on the display. The display returns to ‘0’ after a few
seconds. It is now ready to play.
M»- H TRACK H POWER
o o o o
ISPLAY REPEAT CHECK PROG :
C
o o o
PLAY ►
Press to play the CD. To restart the disc from track I, press ‘STOP’
and then ‘PLAY’.
Note:
Make sure your amplifier (input source selector) is set to CD.
HDCD encoded CDs will be recognised automatically by the
Alpha 8SE and 9CD players.To indicate this, a red LED (Light
Emitting Diode) will illuminate behind the Arcam badge in the top
left hand corner of the front panel whenever an HDCD disc is
playing.
STOP ■
Press to stop the CD playing.
The display will show an ‘0’ and the number of tracks.
PAUSE ■■
Press to pause the disc (interrupt play).
Press ‘PAUSE’ again to resume play from the same point.
LOAD PLAY STOF
o o o o
SEARCH ►►
Press MM to search back or ►►to search forward, for a particular
passage during play. If the player is in ‘PAUSE’ mode the search will
be at high speed and the sound will be muted (you will hear
nothing).
TRACK - PREVIOUS or NEXT H H
To start the CD with a track other than the first one, press H
or to locate your desired track, then press ‘PLAY’.
To select another track during play, press H or H to locate the
track. The player will automatically ‘PLAY’ after you have selected
the track. Pressing [◄ once will restart the track currently playing.
To select the previous track, press twice. To go back two
tracks, press !◄ three times, and so on.