Seat assembly (hardware a), Steering wheel installation (hardware b) – Bolens 138-784-401 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEAT ASSEMBLY (Hardware A)
1.----- Place the seat in position against the seat brackets.
Secure each side of seat with shoulder bolts, lock
washer and hex nut. Crown side of washers should
be against the head of the bolt and the nut. See
------- figure 3.
2.----Plug the wire lead which is in the wire harness
beneath the seat into the plug on the wire lead ex
tending from the right hand side of the seat. Make
certain to route the wire in front of the right hand
seat bracket so the wire is not pinched when rais-
----- ing and lowering the seat. See figure 4.
STEERING WHEEL INSTALLATION (Hardware B)
Your unit is equipped with indicator lights, located in
the steering wheel. The steering wheel must be
assembled as follows for proper operation of the in
dicator lights.
1. Open the hood of the tractor.
2. Place the larger end of the steering bellow over the
wire harness extending through the steering wheel
(bellow must fit over the four tabs on the steering
------- wheel). See figure 5.
3. Insert the ends of the wire harness down through
the hole in the dash. Then slide the wires through
the slot into the smaller hole in the dash to the stop
(tape) on the harness as shown in figure 5. Only
about 6" of wire will extend beneath the dash.
4. Plug the three connectors on the wire harness in
to the corresponding connectors on the tractor.