Bolens LT-185 - Manual (Page 10)

If adjustment is needed, proceed as follows.
1. Remove the hairpin clip and flat washer from the
bottom of the adjustable lift link on the left side of
the deck. See Figure 7. {Hairpin clip and flat
washer are on the inside of the lift link.)
2. Pull the adjustable lift link out of the deck
hanger. Turn the adjustable lift link up or down
as necessary to level the deck. Usually only one
or two turns are needed.
3. Insert the end of the adjustable lift link into the
hole in the deck hanger. Recheck the
adjustment. Readjust if necessary.
4. When deck is level, secure end of adjustable lift
link with flat washer and hairpin clip.
INSTALLING THE BATTERY (TYPE “A”)
NOTE: If battery is put into service after date
shown on top of battery, charge for minimum of 1
hour at 6-10 amps.
1. Lift the seat.
2. Remove the plastic cover from the negative
terminal.
3. Remove the hex bolt and nut from the negative
(black) cable. Attach negative cable to the
negative terminal with this bolt and nut.
Positive Terminal
(Inside Rubber Boot)
Negative
Cable
Negative
Terminal
Figure 8
Battery
Compartment
Battery
INSTALLING THE BATTERY (TYPE “B”)
1. Lift the seat.
Make certain both the negative (black) cable and
the positive (red) cable are routed up through
the battery compartment as shown in Figure 8.
Replace the battery into the battery
compartment in the same position as it was
before (positive terminal is toward the front of
the unit).
2 .
3.
10