Bunn BT10 User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Remove the pour-in bowl and set it aside.
NOTE: Save your screws, in case you misplace any of the seven included in
the kit.
Please call
1-800-385-2652
should you have any
questions about the
installation of your
Protective Shield.
A. Gently move the wires and silicone tube aside before putting the Protective Shield in place.
B. Set the Protective Shield over the top of the heater terminals and sprayhead tube and gently push
into place.
C. Make sure the silicone tube is not under the edge of the shield.
Advertising