Bolens 134-585A - Manual (Page 6)

Assembly
Compare the wiring of the bat­
teries against figure 4 to be sur«
the batteries are wired as they
should be. Batteries that are
wired wrong could cause a
dead short when they are
activated.
Figure 4
2 It will be necessary to purchase
locally 18 quarts of Sulphuric
Acid Electrolyte (Sp. Gr, 1.265)
to activate the battery.
3 Cut the sealed end from the fill
tube on the acid pack. (See
figure 5.)
4 Pinch the tube to keep the acid
from flowing from the tube
until you have the acid pack in
position as shown in figure 6.
Figure 5
Fill the batteries with the acid.
Only fill them until the acid
level is 14” above the plates.
Do not fill to the split ring at
this time.
6 Charge the batteries as outlined
in the Maintenance Section of
this handbook.
7 Add the remaining acid to fill
the batteries to the split ring.
Tire Pressure
For shipping purposes, the tires on
your unit may be over-inflated. Tire
pressure should be reduced before
unit is put into operation. Pres­
sure should not exceed 15 P.S.I.
Equal tire pressure should be
maintained.
Figure 6