Audiovox MVX-430 - Manual (Page 11)

Automatic Storing into a Vacant
Memory Address
This feature allows automatic storing into a vacant rep­
ertory memory address. This ends the possible problem
of writing over a previously stored number.
1. Enter the phone number.
2. Press key then (?3-
3. The number will be stored automatically to the
memory address of the smallest number among the
available vacant locations. The memory address
and the last 5 digits of the stored phone number
will be displayed on the readout as follows.
Example: 131S1-] ■■|г|ЗRT51
Note; If there is no vacant address, the phone number
will not be stored in the memory.
To lock the Unit
Press then key ©(LOCK).
The I LOCK I indicator hghts. The unit will remain locked
until unlocked, even if the power is turned off.
To Unlock the Unit
Enter the three-digit unlock code. The ILOCKI indicator
will go out when the three-digit code is the same as the
code registered in the NAM.
Volume Control
The audio level of the earpiece and the alert tone can
be adjusted by the Volume Control Key ®,
• Earpiece:
Keep pressing ® until you get the desired sound level.
Soxmd level will be displayed on the readout digitally
during the level adjustment and the sample tone will
indicate the sound level when you are not engaged in
a telephone conversation. The display format is as
follows.
h R5
• Alert Tone:
Press ® key. Then adjust the alert tone level in
the same manner as above. Your telephone will ring at
the new level. In this case, the display format is as
follows.
PLACING TELEPHONE
CALLS
To Place a Call
1. Enter the phone number. The last 8 digits of the
dialed number are displayed on the readout,
2. If a dialing error is made, press ®, then enter the
phone number again. Pressing ® momentarily
(less than approx, 0.5 sec.) clears only the last digit.
3. Press The IINUSEi indicator will light. When
the called party answers, proceed with your
conversation.
If the Call Fails to Go Through
If you hear the “reorder” signal, press then if
there were no dialing errors, press for redial.
(Redialing with digit keys is not necessary.)
If
the“intercept”signal is heard, press then
redial the correct number.
1 .
2 .
Automatic Redial (NAM Option)
If the feature of Automatic Redial (NAM Option) is
selected, your unit will automatically make seven at­
tempts to reach the cell site when the first try is not
successful.
The liN USEi indicator will stay on, but the speaker will
be muted for thirty seconds. This is done so that you
do not hear the reorder signals out of the speaker. If
you need to terminate the automatic redial, press
C^.
Terminating a Call
Press and the IINUSEI indicator will go out.
To Receive Calls
1. When the telephone rings, press to answer the
call. The II^SEI indicator will light.
\ R \ i \ k
(X = 1-5)
19 20