Warning, Note, Caution – Bolens 2182 User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Remove the throw-away-can-type filter and replace

with a new filter after the first 10 and 50 hours of

operation, and every 100 hours of operation
thereafter. The filters can be obtained through your

Cub Cadet Dealer under part number 723-3014.

To remove the filter, turn the filter counterclockwise
using an automotive-type filter wrench.

Before installing the new filter, apply a coating of oil on

the filter gasket. Thread the new filter on by hand until
tight enough to seat the gasket. Loosen the filter.
Then turn it until the gasket contacts the base.
Tighten the filter an additional 1/2 turn. Start engine
and allow it to run for a few minutes. Shut engine off
and check for leaks; check oil level in transmission
case.

SPARK PLUGS

A

WARNING

To avoid possible injury, be sure engine is
off and cool before making any adjustment
or repairs.

NOTE

Remove all dirt from around the spark plugs

before removing.

To remove spark plugs, always use a spark plug

wrench. Check gap after every 200 hours of opera­
tion.

Replace a defective plug with a new plug. Set gap at

0.043 inch. (See Figure 44.) Tighten plug to 14.5-

18.1 ft-lbs. See your authorized dealer for the correct
replacement plug.

1. Spark Plug

FUEL FILTER

A

WARNING

The engine is equipped with an inline fuel filter. Visu­

ally inspect the filter periodically. Replace yearly or

when dirty. (See Figure 45.)

LIGHTS
Refer to "SPECIFICATIONS" when replacement of
head lamp bulb or taillight bulb is necessary.

A

WARNING

Do not change head lamp bulbs when hot or

when engine is hot.

A

CAUTION

Do not touch glass portion ot head lamp

bulb. Touching glass portion will reduce life

of head lamp bulb.

NOTE

Prior removal of battery will ease removal

and replacement of head lamp bulbs.

To replace a head lamp bulb, refer to Figure 46 and

remove the socket from the grille by rotating socket
1/4 turn. Pull old bulb assembly from socket and
insert new bulb assembly. Place socket into grille and

turn to lock in place.

Do not replace fuel filter when engine is hot.

28

Advertising