Bolens 2182 - Manual (Page 37)

LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
AntlClplated Air Temperatijre
77°F and above 32°F to 77°F 32°F to 0°F
Engine crankcase Check
before
each
use
35
and
100
approx.
3.4 qts
including
oil in
oil filter
Cub Cadet
Low Ash
Engine Oil
SAE 30W or
SAE10W-30
Engine Oil
SAE 20W or
SAE10W-30
Engine Oil
SAE 10W or
SAE10W-30
Hydro-drive unit
mounted on trans­
mission case with
filter Check
before
each
use
Add
as
needed
Approx.
14 pints Cub Cadet Hydraulic Transmission Fluid
NOTE: Cub Cadet hydraulic transmission fluid meets
IH B-6 specifications. If fluid is used that does not
meet these requirements,Cub Cadet will not be respon­
sible for substandard performance. Failures due to use
of improper fluid are not covered by warranty. For
maximum protection, use Cub Cadet Hydraulic Trans­
mission Fluid.
Steering knuckles &
front axle pivot bolt 10 Use 251H EP grease or equivalent No.2 multi-purpose
lithium grease and apply two or three strokes or suffi­
cient grease to flush out old grease and dirt.
Front wheel
bearings 35 Two or three strokes minimum of the lubricator using
251H EP grease or eqivalent No. 2 multi-purpose
lithium grease.
Alignment couplings 251H EP grease or equivalent No. 2 multi-purpose
lithium grease.
37