Bolens 137-360-300 - Manual (Page 3)

ASSEMBLY
GRASS CATCHER Model No. 197-015A is
available as optional equipment for the mowers
shown in this manual.
\
WARNING
I
The mower should not be operated
without the entire grass catcher or
chute deflector in place.
NOTE
Under normal usage bag material is
subject to wear, and should be
checked periodically. Be sure any re­
placement bag complies with the
mower manufacturer’s recommen­
dations.
For replacement bags, use only fac­
tory authorized replacement bag No.
764-0121.
A
CAUTION
Installation of tire to rim :
1. Lubricate tire beads and rim
flanges.
2. Do not exceed 30 P.S.I. when
seating beads.
3. Adjust to recommended pressure
after beads are sealed.
I '■
t '
V
(1)1/4" Flat
Screwdriver
•r-
Wrench
\/
(2) 7/16" Wrenches
FIGURE 1. TOOLS REQUIRED FOR ASSEMBLY
The manufacturer DOES NOT recommend the use
of any accessory on these riding mowers other
than those manufactured by MTD Products Inc.
Your mower is shipped assembled except for the
steering wheel assembly and hood. These parts,
with the necessary hardware, are easily assem­
bled to the machine, as outlined.
NOTE
Reference to right-hand or left-hand
side of machine is from the driver’s
seat facing forward.
Long Truss Screws
P ^uts V4-20
Lockwashers
V4”Scr.
steering'^
Wheel
Steering Sha'
Steering Wheel
Cap
ex Nut
/16-18
Thd.".
Bell.-^-i
Washer ^
Wave Washer
Tube Clamps
V4-20Thd.
Hex
Scms
i» .^»-'Cent. L-Nuts Bolts
*• :
V4-20Thd.
TIREPRESSURE
FOR SHIPPING PURPOSES, THE TIRES ON
YOUR UNIT MAY BE OVER-INFLATED. TIRE
PRESSURE SHOULD BE REDUCED BEFORE
UNIT IS PUT INTO OPERATION. PRESSURE
SHOULD BE APPROXIMATELY 15 P.S.I. EQUAL
TIRE PRESSURE SHOULD BE MAINTAINED.
MAXIMUM TIRE PRESSURE 30 P.S.I.
FIGURE 2. PARTS IN CARTON AND HARDWARE
PACK
, ■ V. CAUTION
Do not use rear plastic cover to lift
unit.