Note, Seat assembly, Four position adjustment – Bolens 131-730A User Manual
Page 6: Steering wheel installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Place the battery in the battery box with the
terminals towards the rear of the tractor.
2. Secure the battery with the two hoid down
rods, battery hold down, lock washers and
wing nuts. See figure 1.
FIGURE 1.
3. Attach the positive cable (from the starter
solenoid) and the small wire (from the circuit
breaker) to the positive battery terminal (-f)
with a V4-20 X
3
/
4
" long bolt, lock washer and
hex nut.
4. Attach the negative cable (grounded) to the
negative battery terminal (-) with the other
V
4-20
X
3
/
4
" long bolt, lock washer and hex nut.
NOTE
The vented battery allows any gases
or liquid from the battery to be car
ried to the rear of the tractor and on
to the ground.
Route the rubber drain tube down beside the trac
tor frame so it drains onto the ground.
SEAT ASSEMBLY
The seat can be adjusted to four positions. With
the seat tipped forward, hook the front of the seat
spring into the slots on the tractor frame. Allow
the seat to pivot backwards until it rests on the
rear of the springs. (See figure 3.)
N '
'
FOUR POSITION ADJUSTMENT
FIGURE 3.
STEERING WHEEL INSTALLATION
1. Place the steering wheel over the steering col
umn extending through the dash. Line up the
flats on the steering column with the flats in
the steering wheei. (See figure 4.)
FIGURE 2.
FIGURE 4.