Figure 26, Handle storage – Bolens 122-336-120 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Engagement
FIGURE 26.
HANDLE STORAGE
FIGURE 27.
The handle can be stored in an upright position to
take less space. See figure 27. Remove engage
ment rod. Move hairpin cotters to outer hole on
weld pins (see figure 4). Grasp the lower handle at
the bottom and pull apart slightly. Tip the handle
forward. It will lock in this position. Reverse this
procedure to place the handle in the operating
position.
The handle may also be folded away completely.
See figures 28 and 29.
1. Remove engagement rod.
2.
Remove hairpin cotters from inner hole on
weld pins on handle mount brackets. Place in
outer hole.
3. Loosen the two hand knobs on the inside of
the handle.
4. Pull outward on the bottom of each side of the
lower handle, and push forward.
5.
Fold the upper handle back and down as
shown.
15