Bolens 122-336-120 - Manual (Page 16)

To take the handle out of storage position, pro­
ceed as follows.
1. Lift the upper handle up and towards the rear
as shown.
2. Pull the handle back until it locks into the
operator’s position.
3. Tighten the two hand knobs securely.
4. Move the hairpin cotters to the inner hole on
the weld pins.
5. Reassemble engagement rod. Check engage­
ment rod adjustment.
1. Working outdoors, drain all fuel from the fuel
tank. Use a clean dry cloth to absorb the small
amount of fuel remaining in the tank. Then run
the engine until all fuel in the carburetor is ex­
hausted.
®
t* w V rn T ng ^I
Do not drain fuel while smoking, or
if near an open fire.
s.. ....
■ ' « ' • ■ - 1 .
2. Drain all the oil from the crankcase (this
should be done after the engine has been
operated
and is still warm). Refill the
crankcase with clean new oil.
3. Disconnect the spark plug wire and remove
the spark plug from the cylinder. Pour about 2
or
3 tablespoons of engine oil into the
cylinder. Turn the engine over several times to
spread out the oil. Replace the spark plug, but
do not connect the wire.
4. Clean the engine and the entire mower
thoroughly.
5. Lubricate all lubrication points.
FIGURE 28.
f
iiwfcl
h
FIGURE 29.
OFF-SEASON STORAGE
If the machine is to be inoperative for a period
longer than 30 days, the following procedures are
recommended:
16