Assembly, Assembly instructions – Bolens 111-064A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 3.
Four
Cutting
Heights
ASSEMBLY
INSTRUCTIONS
(Hairpin (T) Handie)
NOTE
This
unit
is
shipped
WITHOUT
GASOLINE or OIL. After assembly,
see
operating
section
of
this
manual for proper fuel and engine
oil recommendations.
Your new mower is shipped preassembled with
the exception of the handle and wheels.
1. Remove lawn mower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the car
ton is discarded.
NOTE
Throttle
control
may
be
optional
on your unit.
2. Extend throttle control assembly which is at
tached to engine at the rear of the mower and
place on floor.
A CAUTION
Do not bend or kink control wires.
-3. Place lower handle in line with hole on deck.
Secure to deck with shoulder bolts (I), lock
washers (J) and hex nuts (K). See figure 3.
NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to assure a snug fit against
the deck mounting area.
Belleville Washer
Wheel
4. Your mower has four height settings. Use the
same hole for all four wheels when assem
bling. See figure 4.
-5. Place shoulder bolt (F) through wheel. See
figure 4.
6. Place crown side of belleville washer towards
the wheel (away from deck). See figure 4.
7. Secure wheel to deck, using hex nut (H) and
lock washer (G).
FIGURE 4.