Aiwa CX-NA71 - Manual (Page 19)

PROGRAMMED EDIT RECORDING
r
a
Programmed edit function enables CD recording while checking
the remaining time on each side of the tape as the tracks are
programmed.
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the r 6 ma''in''in 9 time
cannot be programmed.
Remaining time
of side A
Total number
of programmed
tracks Programmed
tracks
7
Press the CD EDIT/CHECK button to select side
B and program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
aj--.
o
z
Q
cc
o
o
LU
■
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
1
Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press the CD button and load the disc(s).
3 Press the CD EDIT/CHECK button twice.
“EDIT” and “PRGM” light up on the display.
PRGM EDIT
J ^
4
Press the ◄◄ or ►► button to designate the tape
length.
10 to 99 minutes can be specified.
Tape length
Maximum recording
time for side A
Tape side A (front side)
5 Press the DISC DIRECT PLAY button, then press
one of the numbered buttons 1 to 3 within 3
seconds on the remote control.
Then, press the numbered buttons and the + 1D
button on the remote control to program a track.
Example: To select the 10th track of disc 2, press the DISC
DIRECT PLAY and 2 buttons, then press the + 10 and 0
buttons.
8
Press the # REC/REC MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press the CD EDIT/CHECK button to select
side A or B, and press the ◄◄ or button repeatedly.
. Program number
I
Track number Programmed
track numbers
To change the program of each side
Press the CD EDIT/CHECK button to select side A or B, and
press the ■ CLEAR button to clear the program of the selected
side. Then program tracks again.
To clear the edit program
Press the ■ button twice so that “EDIT” disappears on the
display.
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENGLISH 1 8