Bolens TMO-37478A - Manual (Page 7)

split Washer
Hex Nut
ATTACHING THE UPPER HANDLE (Hardware B)
Place upper handle in position over lower handle. The
label on the throttle control housing and the control
lever must be facing up. Secure upper handle with two
curved head bolts, split washers and hex nuts. See
■figure 2.
FIGURE 2.
FIGURE 3.
ATTACHING THE BLADE BRAKE/CLUTCH CABLE
(Hardware O)
The blade brake/clutch cable is the cable which has
an “L” fitting on the loose end. and is attached to the
blade brake/clutch underneath the deck.
1. Route the blade brake/clutch cable to the outside
of the catcher panel and height adjustment lever,
and under the lower handle. Place end of cable into
the upper hole on the bottom of the control hous­
ing, and through the slot on the side of the hous­
ing as shown. The angle of the plastic flange must
------ be positioned downward as shown in figure 3. Be
careful not to bend or kink the cable at any time,
2. Push the plastic flange until it locks into the con­
trol housing.
A i
WARNjNG
^
The cable must be assembled as
shown for proper blade brake/clutch
operation.
3. Insert the “L” end of the blade brake/clutch cable
into the hole in the blade brake/clutch control han­
dle, from the inside to the outside as shown in
—figure 4. Hold the end of the cable, and press push
cap on by hand.
FIGURE 4.