Bolens TMO-37478A - Manual (Page 9)

FIGURE 8.
Grass Catcher
Handle—
/
}\
■ Upper Bag
Support
Truss Machine
Self-Tapping ,
Screw (
Plastic
Channels
Brackets
FIGURE 9.
SECURING THE CABLES (Hardware E)
Secure all cables to the grass catcher panel and lower
handle as toltows.
A. Open the cable clamp provided in your hardware
pack, and slip the cables inside. Remove the up­
per hex nut and lock washer from the side of the
catcher panel. Attach cable clamp as shown in
----- figure 9A. Secure with lock washer and hex nut.
B. Place the height adjustment lever in the lowest posi­
tion. Insert posts on cable ties into holes provided
on the left side of lower handle, one near the top
and one near the bottom of the handle. The holes
may be on either the inside or outside of the han­
dle. See figure 9B.
C. Secure the cables with the cable ties, making cer­
tain to take the slack out of the cables so they do
not contact the wheel. See figure 9C.
D. Trim excess ends of cable ties.
ASSEMBLY OF GRASS CATCHER (Hardware F)
1. Place bag over frame (black plastic side is the bot­
tom of bag). Handle on frame goes to the top of
bag. Brackets hook toward the front. See figure 9.
2. Secure bag to frame by slipping plastic channels
-------on bag over frame. See figure 9.
3. Insert the upper bag support into the pocket on the
rear of the bag. Place grass catcher handle on top
of grass catcher support as shown in figure 9. The
handle should hook toward the rear of the bag as
shown in figure 9. Secure with two truss machine
self-tapping screws.
TO ATTACH BAG TO MOWER
A
WARNING
DO NOT operate the mower unless the
complete grass catcher or side chute
deflector is properly mounted on the
mower.
1. Hook the handle on the rear of the grass catcher
over the lower handle of the mower. See figure
—10A.
FIGURE 10.
2. Hold the chute door on the catcher panel open as
shown in figure 10B.
3. Slide the frame of the grass catcher down into the
channels on the catcher panel. The top portion of
the frame goes over the catcher panel.
4. Secure the grass catcher by turning the locking
lever to the locked position as shown in figure IOC.
To remove the grass catcher, turn the locking lever to
the unlocked position, unhook the rear handle and lift
the grass catcher straight up.