E. conveyor reassembly into oven – Blodgett S1820G User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E. Conveyor Reassembly Into Oven
1. Lift conveyor and position it in oven as shown.
NOTE: Conveyor may be inserted into either end of oven,
if it is to be instailed from the non-drive end of the oven the
drive sprocket assembly must be removed as shown in
conveyor disassembly section.
SECTION 4
MAINTENANCE
Figure 4-21.
2. Reinstall the conveyor extension.
Conveyor Extension
Figure 4-22.
F. Checking Conveyor BeItTension
WARNING
Oven conveyor belt must be cool when adjusting
belt. Do not adjust belt if HOT.
1. With the conveyor assembly in the oven, stand at one
end of conveyor and check tension by lifting the conveyor
belt at the center of the oven chamber opening. The belt
should not lift higher that
T
to 4" (75mm to 102mm).
2. Adjust conveyor belt tension screws (located on left
end of oven) for the 3" to 4"^ (75mm to 102mm) deflection,
as shown in Figure 4-23. If there is propertenslon, proceed
directly to “H. Attaching Drive Chain”. If belt is still loose,
continue to step 3 below.
3. If conveyor belt is still not under proper tension, an
entire link must be removed. Use the following procedure
“G. Conveyor Belt Link Removal” to remove a link, if
conveyor belt is under proper tension, proceed directly to
“H. Attaching Drive Chain”.
36