Bolens 1208 - Manual (Page 11)

SEAT ADJUSTMENT
The seat may be adjusted to different positions. To ad­
just the seat, loosen the four self-tapping screws which
secure the seat to the seat bracket. See figure 14. Slide
the seat to desired position and retighten the self-
tapping screws.
STEERING WHEEL ADJUSTMENT
There are three height positions for the steering wheel.
See figure 15. To adjust, proceed as follows.
Remove the steering cover by removing four self­
tapping screws. Remove the hex bolt and hex lock nut
on the steering shaft.
Raise or lower the steering shaft to desired height.
Secure with the hex bolt and hex lock nut. Reassem­
ble the steering cover.
FIGURE 15.
CARBURETOR ADJUSTMENT
A WARNING: If any adjustments are made to
the engine while the engine is running
(e.g. carburetor), disengage all clutches
and blades. Keep clear of all moving parts.
Be careful of heated surfaces and muffler.
Minor carburetor adjustment may be required to
compensate for differences In fubi, temperature,
altitude and load. To adjust the carburetor, refer to the
separate engine manual packed with your unit.
NOTE: A dirty air cieaner will cause an engine to run
rough. Be certain air cleaner is clean and attached to
the carburetor before adjusting carburetor.
A
LUBRICATION
WARNING: Always stop engine and
disconnect spark plug wire before clean­
ing, lubricating or doing any kind of work
on riding mower.
Engine—Maintain the engine oil according to the
engine manual.
Front Wheels—The front wheels are provided with
grease fittings. Lubricate at least once a season with
automotive multi-purpose grease.
Front Axle—The front axle assemblies are provided
with grease fittings. Lubricate at least three times a
season using automotive multi-purpose grease.
11