Lcm5620pkg system wiring diagram – Audiovox LCM5620PKG User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LCM5620PKG SYSTEM WIRING DIAGRAM
W*SttR«?'<rOB
•SUffl
.’Л>»ПОЯ
tumj uikM
II rm roa.c*st£^^
1. ) Make sure Iho Master, and slave monitor have been installed properly, as described in the proce
dures as slated on pages 4,6. and 6.
2. ) ConnecUhe ГЛО 13 pin DIN terminals of the System Main Cable to the corresponding DIN terminals
of Master Monitor and Slave monitor on the bottom of the seats. Labe! the DIN terminal of System
Main Cable Master to connect to the Master monitor. The other DIN terminal of System Main cable
should be labeled as Slave and connect
to
Ihe Slave monitor.
3. ) There are Three RCA Jacks on the other end of the System's Main Cable, v/hich are labeled as Audio
#1 UAudioSt R/video #"
1
. These jacks need lo be connected to tiie respective AV plugs. Tlie AV cable
nome from AV source #1.
4. ) The IR repeater LED Uial is labeled LED#1 is utilized to connect to AV Source AlLED/il has an
adhesive that allov/s it to adhere to the AV Source #1 Remote Sensor Eye. Remove the backing
covering the adhesive and place LED #1 directly over the Remote Sensor Eye. NOTE: In some
cases you may need to offset the LED lo achieve proper operation, inside this LED cable there is a
2 pin JST terminal in series with the LED. Insert this terminal ю AV source #1 if it has a 2 pin JST type
socket that can accept a direct coded 38kHz signal.
5. ) Repeat item three and four for connecting AV source #2.
^.)
Both sources can now be conVicIled witt-i the Master Monitor IR Repeater Circuit.
7. ) The System Main Cable also gels connected to the vehicle's accessory power terminal.
8. ) The two RCA Jacks on the system Main Cable, labeled as Audio L'Audio R for connecting Ihe FM
Modulator. Please refer to Ihe wiring instructions of the separately purchased FM Modulator {Audiovox’s
model FMM100 is recommended).