AEG 155 D User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Drill four holes in the base of the wall unit using the template
Wall unit
supplied.
mounting
Mount the hood unit on the base of the wall unit using four
4,2
X
35 mm screws.
-Fig.4
If using an interchangeable model, fit the plastic caps supplied in
any unused mounting holes. —
Fig. 5
Position the template on the wall.
Drill four 8 mm 0 holes in the wall, 2 in points
H
and 2 in points I.
Fit the four 8 mm screw anchor plugs in the wall.
Screw two 5 X 45 mm screws in points
H
but do not tighten
them fully home.
Adjust the unit so that it is positioned at a right angle to the wall
by turning the two support screws G.
Now hang the hood on the wall (holes
H).
Tighten the first two
screws and, for safety’s sake, screw the other two 5 x 45 mm
screws (holes I) Into the holes in the hood. —
Fig. 6
Wall
mounting
29