Dish Network EZ Remote - Manual (Page 18)

16
6. Write the number in step 2 from page 13 into the
blank in step 10 below.
7. Press and hold the until both lights
turn on (it takes about five seconds).
8. Release and light will flash.
9. Press the RECALL button.
10.Enter 0- .
11.Press the MUTE button while watching light.
12.If the light flashes three times, go to
step 13. If light does not flash, go to step 7
and try again.
13.Press . Make sure your VCR tunes to the
channel in step 10.
14.Press the MENU button. If you see the satellite
receiver Menu screen, go to step 26. If not, go to
step 15.
15.Answer the questions in the Table 2. The
information you provide is what you will use to
teach your remote control to change the channel on
your VCR correctly.
SAT TV
SAT
SAT
SAT
SAT