Aquapro Fish Feeders ATX User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7
Detach the mounting bracket from the unit by
depressing the two retainer ciips and sliding the
mounting bracket away from you. (Illustration C)
8
Now position the mounting bracket over the
hole in the container making sure the hole is
the same size as the hole in the top of the unit.
(Illustration D)
9
Install the four #8 x %” sheet metal screws
into each of the four mounting holes on the poly
barrel and tighten. (Illustration D)
10
Proceed directly to step 16.
IF NOT MOUNTING TO A AQUA PRO
POLY BARREL.
/1 ^ Detach the mounting bracket from the
J___ Lunit by depressing the two retainer clips
and sliding the mounting bracket away from you.
(Illustration E)
i»1 ^ Now position the mounting bracket over the
J-^hole in the container making sure the hole
is
1
V
2
"-
2
” wide.
/1 OMark the four mounting holes to be drilled.
^OlVIake sure that the metal shutoff lever is
facing toward the front of the feeder in the direction
you wish for the feed to be disbursed. (Illustration F)
14
Drill the four holes with a
V
drill bit.
(Illustration G)
PAGE 4
PAGE 5