Dell PowerEdge 2420 - Manual (Page 24)

22
Installation Guide
Adjusting the Rack Posts (optional)
The position of the rack posts can be adjusted to accommodate systems
of various depths.
1 Open the rack doors.
2 Remove the screws from the bottom and top of the post (see Figure 1-13).
3 Move the post to the desired location inside the side of the rack,
and replace the screws in the corresponding holes.
Figure 1-13. Adjusting the Rack Posts
NOTE:
You may now install systems into the rack. Use the white numbered labels
on the front and back of the rack mounting rails to help install products in the rack.
1 screws 2 back rack post
3 front rack post
1
2
3