Venting installation instructions, Continued – Desa CHDV36NRA User Manual

Page 9

Advertising
background image

111252-01B

For more information, visit www.desatech.com

For more information, visit www.desatech.com

9

9

WARNING: Do not recess vent termination into

any wall. This will cause a fire hazard.

6.

Noncombustible Exterior Wall:

Position the horizontal vent

cap in the center of the 8

1

/

2

" round hole and attach to the exte-

rior wall with four wood screws provided. Before attaching
the vent cap to exterior wall, run a bead of non-hardening mastic
(pliable sealant) around the outside edges to make a seal be-
tween it and the outside wall.

Note:

The four wood screws

provided should be replaced with appropriate fasteners for
stucco, brick, concrete, or other types of sidings.

Combustible Exterior Wall:

For vinyl siding, stucco, or wood

exteriors, a siding standoff may be installed between the vent
cap and exterior wall. The siding standoff prevents excessive
heat from damaging the siding materials. Siding material must
be cut to accommodate standoff. Bolt the vent cap to the stand-
off. Apply non-hardening mastic around outside edge of stand-
off. Position the standoff/cap assembly in the center of the 10

3

/

4

" square hole and attach to exterior wall with wood screws

provided (see Figure 11). The siding standoff must sit flush
against the exterior fascia material.

7.

Combustible Exterior Wall Only:

Slide the wall firestop over

the vent pipe before connecting horizontal run to vent cap (see
Figure 12).

8.

Carefully move fireplace, with vent assembly attached, toward
wall and insert vent pipe into horizontal termination. The pipe
overlap should be a minimum of 1

1

/

4

".

VENTING INSTALLATION
INSTRUCTIONS

Continued

VENTING INSTALLATION INSTRUCTIONS

Installation Planning (Cont.)

Figure 10 - Installing Horizontal Vent Cap
(Noncombustible Exterior)

Wood Screw

Vent Cap

Figure 11 - Installing Siding Standoff (Combustible
Exterior Wall)

Vent Cap
(Horizontal
Termination)

Interior Wall
Surface

Wall
Firestop

Horizontal
Vent Pipe

Figure 12 - Connecting Vent Cap with Horizontal Vent Pipe

Screw

Cut Siding Away
to Fit Standoff

Wood Screw

Screws

Standoff

Vent Cap

Apply Mastic
to All Four Sides

Advertising
This manual is related to the following products: