Call extension, Wiring precautions, 3 instructions on installation & wiring – Aiphone VIDEO SENTRY PANTILT MY-1CD User Manual

Page 2: My-1cd video-monitor, Pantilt door station

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

3 INSTRUCTIONS ON INSTALLATION & WIRING

MY-1CD video-monitor

MY-1CD are designed for indoor use only. Do not mount the video-monitor
in the following places as it may cause the system to malfunction;

• High temperature areas, or near equipment that varies in temperature.
• Extreme cold temperature areas
• Places subject to moisture or humidity extremes.

Mount the video-monitor so that the center of monitor screen comes to the

eye level of the user.

PanTilt door station

MY PanTilt door station employs CCD camera system and the performance

can be affected by bright direct light: strong sunlight, gate light, or street or
porch light which come directly into the camera lens.

As shown, the image viewing area can be expanded by
activating door station camera. The MY-CA door station

may be used as overhead camera, by placing inside the
MYW-CA enclosure.

Pantilt camera vision at 50 cm (20") distance
(vertical X horizontal)

Camera

Horizontal Viewing

Pantilt viewing

MY-CA

51cm

X

72cm

20”

X

29”

90cm

X

110-180cm

36” X 43”~72”

MY-DC
MY-DG

49cm

X

66cm

19”x26”

90cm

X

180cm

36”

X

72”

MY-CA in MYW-CA, downviews the area of 4.7m vert, x 8.4m
horiz. (16’

X

28’) max. from 3 m (10') distance above.

: Shows viewing area of horizontal camera position.

On bottom of Pantilt door back case, cable inlet holes are provided. Do not
apply the back case with caulking seals, etc. Rainwater may pass through
these holes.

Call extension

One IER-2 speaker can be added to sound a chime tone in a remote

location. Connect non-polahzed wires from SO, - terminal on MY-1CD.

Wiring Precautions

Use a single pair (parallel) cable. Coaxial cable or 2 separate

wires can not be used.

When existing doorbell or chime wires must be used, iocate and
disconnect the bell transformer from the wires. Extra pair (s) in the

instailed cabie to video door station can affect the image quality, and
must be terminated with a 120 ohm resistor at each end of wires on both

video door station and video monitor (s).

Taking SG terminai on MY-1CD to earth may help, if noise exists in
communication.

Parallel conductor cable

YES

NO

n

i

I Ó

li

u

-2-

Advertising