Technical precautions, Operation, Installation – Aiphone Myh-Cub User Manual

Page 6: Important, Specifications, Warranty, Aiphone

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TECHNICAL PRECAUTIONS-------------------------------------------------------------------------------------------

Operation:

★ When operating PanTilt control pad, motor sound may be heard. When camera reaches the edge of each direction, release

the control pad. While one person is operating PanTilt or Backlight button, all other MYH-CUB’s can not operate.

Installation:

★ To avoid noise from power supply line, take G terminal of PS-18C or 18D power supply to earth ground.
★ Audio wiring; Keep audio wires at least 20”, 50cm away from AC power lines, fluorescent lights, and dimmer switches.

IMPORTANT:

★ In LEF video system, run two separate cables, with LEF audio wiring together and MYH-CUB wiring together in a completely

separate cable. Using the same cable for both audio and video terminals will cause severe interference to the LEF audio
communications.

SPECIFICATIONS

Power source:
Power supply;

Video monitor:
Scanning line:
Communication:

Wiring:

Wiring distance:

Dimensions:

Weight:

18V DC, 0.4A max. Standby: OA.
Supplid by PS-18C or PS-18D via MYW-P1L or MYW-P3L.

4” direct view flat CRT.
525 lines.
Call-in timer; 45 sec. Monitor timer: 2-1/2 min. during LEF-C communication, extendable with

MONITOR button. Station-Select button activates both audio and video of door camera.

6

or

8

wires, non-twisted, non-shielded between MYW-P1 (3)L and two MYH-CUB.

The same

6

or

8

wires, non-twisted, non-shielded between MYH-CUB’s.

★ Must be separately jacketed from audio cable.

I.Ommo

18AWG

MYW-P1/3L to MYH-CUB 1

75m

245’

MYW-P1/3L to MYH-CUB 1 - 2

35 m

115’

With

8

wires (-

1

-, - doubled)

75m

245’

240 H

X

150 W

X

36 D (mm). 9-7/16” H x 5-5/16” W x 2-7/8” (total).

1

.

0

kg. (

2.20

lbs.) approx.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful Inteference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help.

-i-

-i-

-t-

-i-

-!♦

-S-

-s-

-5-

-t-

WARRANTY

Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two
years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it become defective upon which
examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision
whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in violation of

instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover
batteries or damage caused by batteries used in connection with the product.

This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.

•i*

•i-

-i*

«

1

* ♦

Aiphone Co., Ltd., Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA

MYH-CUB-I(E) 0596D

COMMUNICATION SYSTEMS

® AIPHONE

HOME, BUSINESS, INDUSTRY.

Printed in Japan (E)

Advertising