BodyCraft Tour Trainer Indoor Cycle User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising

Assembly is complete! Please take the following steps before using the

BODYCRAFT TOUR TRAINER INDOOR CYCLE :

1. Make certain all bolts arc tighten securely.

2. Adjust the Seat (101) and Handlebar (103) to your personal settings, and make

certain that all Lock Levers are securely tightened. Note: If the Lock Lever (90)

hits a frame piece, you can disengage the Lock Lever (90) from the screw by pulling

on the spring loaded Lock Lever Handle. Rotate the Lock Lever (90) into a better

position, then release and resume lightening.

3. Wipe sweat away after every use. Failure to do so may result in a rusty bike.

4. Do not over tighten the V-Block Fixed Screws (92). The depth is preset at the

factory. Over tightening can result in stripped threads.

5. You can adjust the side-to-side motion using the large nut at the bottom of the

Springs (19). Tightening the nut w ill stilTen the sidc-to-side motion.

6. Enjoy many years of a fit lifestyle!

Thank you for purchasing the BodyCraft Tour Trainer Indoor

Cycle. If you have any questions, please call your local BodyCraft

dealer, call our customer service department at 800-990-5556 or at

Advertising