Desa BDV34PA - Manual (Page 22)

22 105980
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
®
BDV34NA AND BDV34PA
INSTALLING OPTIONAL
BRICK LINER D8037A
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before
installing brick liner.
This brick liner kit is optional. You may
purchase brick liner from your local dealer
or see Accessories, pages 32 and 33.
CAUTION: Always handle
brick panels with two hands. Do
not force brick panels into place.
Excessive force will break brick
panels.
1. Remove glass door. See Removing/Re-
placing Glass Door, page 21.
2. If installing brick liner in new fireplace,
go to step 3. If installing brick liner in
an existing fireplace, carefully remove
logs, lava rock, and ember material.
3. Install left side brick panel first by slid-
ing it between the grate and the side of
the firebox (see Figure 46).
4. Slide the left retainer bracket against
the left side brick panel. Loosely se-
cure the bracket screw. This secures the
left side brick panel.
5. Install the right brick panel using the
same method described in step 3.
6. Slide the right retainer bracket against
the right side brick panel. Loosely se-
cure the bracket screw. This secures the
right side brick panel.
7. Install rear brick panel. Rest bottom
edge of panel on back edge of grate (see
Figure 47).
8. Loosely secure retainer brackets to
grate. Brackets are adjustable left to
right to allow proper placement of
panel. These will hold rear panel in
place.
9. Tighten all bracket screws.
10. Follow instructions on page 23 to install
logs, lava rock, and ember material.
11. Replace glass door (see page 21).
Figure 47 - Installing Rear Brick Panel and Retainer Brackets
Figure 46 - Installing Left Side Brick Panel
FIREPLACE
INSTALLATION
Continued
Rear Brick Panel
Retaining Brackets
Left Side
Brick Panel