Datamax Allegro 2 - Manual (Page 23)

Allegro2 15
♦
Setting Up Your Printer
2.0 Checking Voltage Selection
The standard Printer is configured for 115 VAC
±
10% single-phase
50/60 Hz with a properly-grounded outlet. A small sticker next to
the power cord connection indicates the power requirements.
For international markets, there is a 230 VAC version available. If
you are uncertain about the configuration of your Printer, or the
outlet you are connecting to, check with a qualified service
technician to verify the installation before connecting power.
2.1 Power Up Self-Test
Once labels are installed in the Printer as described in Section 1.4, a
Self-Test should be performed. The Printer will power up in the
Self-Test Mode when the Feed Button is pressed as the Printer is
being turned on. Initial power up will take approximately 7
seconds. The Printer should be loaded with 4.25" (108mm) wide
stock whenever this test is conducted. The Self-Test prints across
the entire width of the Printhead. Expect a brief hesitation of up to
15 seconds before the Self-Test begins to print.