Operating heater, Inspecting burner, Manual lighting procedure – Desa CGN18RA User Manual

Page 20

Advertising
background image

20

101826

Shutting Off Heater

1. Turn control knob clockwise

Clockwise

to the OFF position.

2. Turn off all electric power to the appliance if service is to be performed.

Shutting Off Burner Only (pilot stays lit)

1. Turn control knob clockwise

Clockwise

to the PILOT position.

MANUAL LIGHTING PROCEDURE

1. Follow steps 1 through 6 under Lighting Instructions, pages 17 and 18.

2. With control knob pressed in, strike match. Hold match to pilot until pilot

lights.

3. Keep control knob pressed in for 10 seconds after lighting pilot. After 10

seconds, release control knob.

TO TURN OFF GAS TO APPLIANCE

OPERATING

HEATER

Continued

INSPECTING

BURNER

Check pilot flame pattern and burner flame pattern often.

PILOT FLAME PATTERN

Figure 18 shows a correct pilot flame pattern. Figure 19 shows an incorrect pilot
flame pattern. The incorrect pilot flame is not touching the thermocouple. This will
cause the thermocouple to cool. When the thermocouple cools, the heater will shut
down.

Thermocouple

Pilot Burner

Figure 18 - Correct Pilot Flame Pattern

GRH/OV 010

BAD PILOT

Pilot Burner

Thermocouple

Figure 19 - Incorrect Pilot Flame Pattern

GRH/OV 009

GOOD PILOT

If pilot flame pattern is incorrect, as shown in Figure 19

• turn heater off (see To Turn Off Gas to Appliance, above)
• see Troubleshooting, pages 22 through 25

Advertising
This manual is related to the following products: