Desa TD120A - Manual (Page 4)

www.desatech.com 122139-01A 4
24. Keep heater away from areas where flam-
mable liquids, vapors or solids are stored
or used.
25. If operated in salt air environments, the
unit will require more frequent cleaning;
otherwise, the longevity of the unit will
deteriorate rapidly. Use warm soapy water
to clean the unit.
26. Items or material, when stored under the
heater, will be subjected to radiant heat
and could be seriously damaged.
Any guard or other protective device
removed for servicing must be re-
placed prior to operating the heater.
Surface temperatures become very
hot when operating heater. Children
and adults should stay away to avoid
burns or clothing ignition.
Young children should be carefully
supervised when they are in the area
of the heater.
Clothing or other flammable mate-
rials should not be hung from the
heater, or placed on or near heater.
Installation and repair should be
done by a qualified service person.
The heater should be inspected
before use and at least annually by
a qualified service person. More
frequent cleaning may be required
as necessary. It is imperative that
control compartments, burners and
circulating air passageways of the
heater be kept clean.
CAUTION: The gas pressure
regulator provided with this ap-
pliance must be used. This regu-
lator is set for an output pressure
of 11" W.C. (2.74 kPa).
SAFETy
Continued
PrOPANE/LP SAFETy
WARNING: For outdoor use
only.
ASPhYxIATION hAzARd
• do not use this heater for heating human
or animal living quarters.
• do not use in unventilated areas.
• The flow of combustion and ventilation
air must not be obstructed.
• Proper ventilation air must be provided
to support the combustion air require-
ments of the heater being used.
• Refer to the Specifications, page 2,
heater data plate or contact dESA heat-
ing, LLC to determine combustion air
ventilation requirements of the heater.
• Lack of proper ventilation air will lead
to improper combustion.
• Improper combustion can lead to carbon
monoxide poisoning leading to serious
injury or death. Symptom of carbon mon-
oxide poisoning can include headaches
dizziness and difficulty in breathing.
UNPAckiNG
When assembling for the first time, be sure to
remove all packaging from the components
prior to beginning assembly.