Dell 4161DS - Manual (Page 24)

24 Installation
www
.d
e
ll.c
o
m
| s
u
p
p
o
rt
.d
e
ll
.c
o
m 2
Attach one end of the CAT 5 cabling that will run between your PEM and the Remote
Console Switch unit to the RJ45 connector slightly separate from the other connectors on
the PEM. Connect the remaining end of the CAT 5 cable to the desired ARI port on the
back of your Remote Console Switch unit.
3
To one of the eight RJ45 connectors grouped on the back of the PEM, attach the CAT 5
cabling that will run between your PEM and each device’s SIP.
4
Connect the other end of the CAT 5 cable to the first of the SIPs.
5
Repeat steps 3-4 for all devices you wish to attach.
Figure 2-8. Remote Console Switch Configuration With a PEM
Connecting to the Network
To connect the network and power up your Remote Console Switch:
1
Connect your network cable to the LAN port on the rear of the Remote Console Switch to
your network.
2
Power up all attached systems.
3
Attach your monitor and keyboard and mouse cable connectors to the appropriate ports on
the back of your Remote Console Switch unit.
Analog User
ARI Port
CAT 5e
PEM
SIP or Avocent AVRIQ
Server